TenTec
[Top] [All Lists]

Re: [TenTec] CW Filters ???

To: "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
Subject: Re: [TenTec] CW Filters ???
From: "Rick - DJ0IP / NJ0IP" <Rick@DJ0IP.de>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 16 May 2012 12:35:04 +0200
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
I won't take you up on that Barry, because you would win!

Remember what we did with the original Orion (1)?
We inserted a 600 Hz INRAD roofing filter in place of the 1kHz filter, and it 
worked just fine with the DSP from 600 Hz, all the way down to 50.

James is already into serious contesting, but so far only on SSB.
He is part of a BIG M2 contesting team in Michigan.
He will soon be needing that 300 Hz filter!

73
Rick, DJ0IP


-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com] On 
Behalf Of Barry N1EU
Sent: Wednesday, May 16, 2012 12:21 PM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] CW Filters ???

On Wed, May 16, 2012 at 5:53 AM, Rick - DJ0IP / NJ0IP <Rick@dj0ip.de> wrote:
> Just an idea, but maybe you could plug it into the 500 Hz slot or tell the 
> software that it is 500 Hz.  That way it would be in the circuit as soon as 
> the DSP is adjusted to 500 Hz or below.
>

Yes, that's exactly what you do - install the 300hz filter as if it's a 500hz 
filter, and it kicks in when dsp selectivity is set to 500hz.
I'm willing to bet that the combination of 300hz filter and dsp at 400-500hz 
would yield outstanding results.

Barry N1EU
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>