Hi Mike,
There is nothing really wrong with the Scout, but it does have a few
quirks. It's sensitive, selective and I don't think you will have a problem
with the Jones filter. I never had a drift problem but then I never could do
much more than 20 wpm. The drift problem, as I understand it, happens with
speeds over about 25wpm and long transmissions with no pauses. If you pause for
a few seconds the vfo will re-lock. Yes an external keyer will solve the
problem.
There are a few birdies due to the digital readout, that pulses with the clock
frequency and of course they are always right on a net frequency that you
operate. I had one on SSB on 14.336 the county hunter frequency but found if
you flipped the switch to cw speed readout it changed the birdie frequency and
didn't cause a transmitt problem except you didn't have a frequency readout.
Other than that I thought it was a great rig. I sold it and bought an Argonaut
V that has a slightly better receiver and doesn't require a plug-in for each
band but power is reduced to 20 watts output instead of 50. Not a real problem
as I see it.
Get it on the air and enjoy.
73 Jim K4CGY
________________________________
From: Michael A. Goltz <whomike@zoominternet.net>
To: tentec@contesting.com
Sent: Saturday, July 7, 2012 6:13 PM
Subject: [TenTec] What's wrong with the Ten Tec Scout?
I have been following the "First Ten Tec" thread by Rick with great interest!
Mine started with a PM3 then a Triton IV then an OMNI A Series B then an OMNI
D then another Triton IV with digital accessory along with a Century 21, a
Century 22 and then I bought a Corsair II. At one time had then all together
and used all of them CW only (no SSB).
I got very sick in 2000 and disposed of all my gear! Everything.
Too make a long story short I am still here. I want ( and need) to get back on
the air and I found a Scout with all the modules and plan to put it on the air
as soon as I get a wire up.
I read the post from the fellow who thought "the Scout was Ten Tec's low
point". I would like to hear from Scout users who love the Scout or hate it. I
want to know about the freq drift(?) when using the internal keyer(?) Will it
be better if I use an external keyer? Will I like the Jones filter after using
250/500 Hz filters? This Scout was back to Ten Tec for a go-over about a year
ago (right before I bought it). I have the 937 Power Supply to use with it.
I plan to use the Scout fixed only-no mobile. And on CW only. Give me your
experiences and thoughts! I would be grateful for any info! Thanks!! Mike
N8CRF whomike@yahoo.com
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|