TenTec
[Top] [All Lists]

Re: [TenTec] TenTec Digest, Power Supplies

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] TenTec Digest, Power Supplies
From: Richards <jruing@ameritech.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 08 Sep 2012 13:13:49 -0400
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Not so, Dick Tracy.

Unfortunately, and I am loathe to knock any team I am on, my TT Model 963 switching power supply (purchased with my Omni VII) puts out hash on frequencies other than ham bands. Not awful, but enough to notice as I use it to run my scanners and SWL general coverage receivers, including a TenTec RX-320D. TenTec says it only tests for noise in the ham bands, so I am stuck with it. Again it is not a show-stopper, but those ARRL tests would not have helped me any.

Thus, I am not totally happy with my TenTec switching supply other than it does not bend the desk top. I built a stand for the two heavy linear supplies under the desk where I cannot kick them, and and they no longer warp the desk top. I am sold on linear supplies, despite the added weight and cost.

Just MY take...

---------------------------  K8JHR  ---------------------------------------

On 9/8/2012 2:39 AM, Rick - DJ0IP / NJ0IP wrote:
Jim, that's why the league tests switcher power supplies for trash.
All you have to do is read the reviews and buy a good one.
You always get trash when you buy cheap, no matter what it is!

________________________________________________





.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>