My N4PY Orion program sets the mode to either UCW or LCW depending on
which one you have defined as the your default CW mode. LCW is the
normal default.
Carl Moreschi N4PY
121 Little Bell Dr.
Hays, NC 28635
www.n4py.com
On 2/27/2013 6:39 PM, leen3lpj wrote:
I use dxlabs a little bit and it also does the same thing .
rig is also an orion .
Lee N3LPJ
----- Original Message ----- From: "Randy Fulco" <rfulco@bellsouth.net>
To: <tentec@contesting.com>
Sent: Tuesday, February 26, 2013 12:02 PM
Subject: [TenTec] HRD cw spots only move to UCW?
Latest version of Ham Radio Delux only moves my Orion to UCW on a Dx
Cluster spot. SSB is correct per band. I sent a msg to HRD -but they
haven't responded? Anyone else noticed this, or heard of a fix? Does
it do this to other Ten Tec's? Thanks Randy K5SL
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|