On Mon, Mar 25, 2013 at 3:25 AM, <nf4r@comcast.net> wrote:
>
>
> Thanks for the reply Bob. I was using the cabinet as gnd. I will recheck
> voltages in the morning and use the board its self as gnd,or the negative
> dc input as gnd.
>
>
No need Dave. I checked the voltages in my Corsair II and they are the
same as your measured voltages. This is just one more case of the Corsair
II manual being wrong.
My transmit audio is fine with my 705 mic. I still think you need to rule
out the mic as your problem. I assume you don't own an external mic preamp
or any other amplified mic besides the one 705?
73,
Barry N1EU
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|