I don't have another amplified mic. The 705 works fine on my paragon,but the
input circuits may be different,also the paragon has mic. gain knob on it ????
Now it gets interesting. Some where
on the net I read about replacing the 100k resister [ r1 ] with 68 ohms or
less. Thanks for the help. I'll let you know. I hate chasing ten tec's ghosts.
73
de nf4r Dave
----- Original Message -----
From: "Barry N1EU" <barry.n1eu@gmail.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Monday, March 25, 2013 4:47:44 AM
Subject: Re: [TenTec] Need help with corsair ii
On Mon, Mar 25, 2013 at 3:25 AM, <nf4r@comcast.net> wrote:
>
>
> Thanks for the reply Bob. I was using the cabinet as gnd. I will recheck
> voltages in the morning and use the board its self as gnd,or the negative
> dc input as gnd.
>
>
No need Dave. I checked the voltages in my Corsair II and they are the
same as your measured voltages. This is just one more case of the Corsair
II manual being wrong.
My transmit audio is fine with my 705 mic. I still think you need to rule
out the mic as your problem. I assume you don't own an external mic preamp
or any other amplified mic besides the one 705?
73,
Barry N1EU
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|