Re: [TenTec] Need help with corsair ii

["Bob McGraw - K4TAX" <RMcGraw@Blomand.net>]

Thanks Barry.  I have the manual but no radio at present to make 
measurements.
73
Bob, K4TAX


----- Original Message ----- 
From: "Barry N1EU" <barry.n1eu@gmail.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Monday, March 25, 2013 3:47 AM
Subject: Re: [TenTec] Need help with corsair ii


> On Mon, Mar 25, 2013 at 3:25 AM, <nf4r@comcast.net> wrote:
>
> > Thanks for the reply Bob. I was using the cabinet as gnd.  I will recheck
> > voltages in the morning and use the board its self as gnd,or the negative
> > dc input as gnd.
> No need Dave.  I checked the voltages in my Corsair II and they are the
> same as your measured voltages.  This is just one more case of the Corsair
> II manual being wrong.
>
> My transmit audio is fine with my 705 mic.  I still think you need to rule
> out the mic as your problem.  I assume you don't own an external mic 
> preamp
> or any other amplified mic besides the one 705?
>
> 73,
> Barry N1EU
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec