The assumption here was that he already owned the Heliax. If I were to buy new
coax for my tower it would be just what I bought last time..Times Microwave
LMR-600. I have 6 150' runs out and up the 65' tower.
No regrets...
Cecil
K5DL
Sent from my iPad
On Apr 25, 2013, at 7:36 AM, "jack" <jfriend31@comcast.net> wrote:
> after all I have read on coaxial cable, I would choose the LMR-400. the
> difference in signal loss at such a short run would not be noticeable to the
> ear.
> jack
> ak7o
>
>
> -----Original Message----- From: GARY HUBER
> Sent: Wednesday, April 24, 2013 10:37 AM
> To: TenTec Reflector
> Cc: SMC ; DX-IS@yahoogroups.com ; W9AML group-email
> Subject: [TenTec] OT: Half inch Andrews Heliax LDF4-50A vs LMR-400
>
> As I consider the materials required to replace my 30 year old tower, rotor,
> antenna and cables, I have several like new runs on LDF4-50A terminated with
> N-male which could run from my ground window (UHF female) to the top of my 53
> foot tower (60 feet max LDF4-50A cable run) where a flexible low-loss 10
> foot jumper would terminate on a new BN-4000 and new TH-7 tribander. This
> configuration would require the 60 feet max LDF4-50A cable run, two half
> inch N female to UHF male adapters, one UHF double female and 10 feet of high
> quality RG8 cable as the jumper to the BN-4000.
>
> The alternative which I’m leaning towards as it seems less likely to have
> connector/adapter loss and other potential problems is a single run of 75
> feet of LMR-400 with factory terminated PL-259s between the BN-4000 and
> ground window UHF female termination. My current installation is 60 feet of
> RG-9913, a UHF double female adapter and a ten foot RG-8214 jumper.
>
> I know the half inch Andrews Heliax has a much lower loss figure (0.357 db
> per 100 feet at 30MHz) for a given length versus the same length of LMR 400
> (0.7 db per 100 feet at 30MHz) , but I’m thinking those three adapters (six
> connection points for loss) and their potential problems make it a wash or
> maybe the advantage goes to the 75 foot run of LMR-400.
>
> I’d be interested in any comments or experiences you might have on the
> subject.
>
> 73 ES DX,
> Gary -- AB9M
>
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|