| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] OT: Latest ARRL ATU Test Results added to MATCHBOX SHOOTOUT |
| From: | Richards <jrichards@k8jhr.com> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Sun, 16 Jun 2013 14:35:08 -0400 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
Footnote - My AT2K has a balun in it...
it is an extra expense accessory
on current models.
------------------- K8JHR ------------------
On 6/16/2013 12:00 PM, Rick - DJ0IP / NJ0IP wrote:
That's because it was measured in 3 different ways: (1) By itself (2) With external 1:1 Balun (3) With external 4:1 Balun The external baluns may be used with either the AT2KD or the AT2K, but ARRL did not measure the 2K with the baluns. _______________________________________________ _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] RF Speech Processor "TX IMD", Richards |
|---|---|
| Next by Date: | Re: [TenTec] RF Speech Processor "TX IMD", Al Gulseth |
| Previous by Thread: | [TenTec] OT: Latest ARRL ATU Test Results added to MATCHBOX SHOOTOUT, Rick - DJ0IP / NJ0IP |
| Next by Thread: | Re: [TenTec] OT: Latest ARRL ATU Test Results added to MATCHBOX SHOOTOUT, Rick - DJ0IP / NJ0IP |
| Indexes: | [Date] [Thread] [Top] [All Lists] |