TenTec
[Top] [All Lists]

Re: [TenTec] Omni VI+ crashed

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Omni VI+ crashed
From: Barry N1EU <barry.n1eu@gmail.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 3 Jul 2013 08:32:24 +0000
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Did you try a Master Reset?  See p2-2 or 2-3 of the manual.

73/GL,
Barry N1EU

On Wed, Jul 3, 2013 at 2:55 AM, <chacuff@cableone.net> wrote:

> Must be one of those evenings...
>
>
>
> Was listening around on my Omni VI and all of a sudden it quit receiving,
> the meter needle bounced once and the display and tuning controls locked...
>  None of the buttons respond.  I cycled the power thinking it had gotten
> confused for some reason and when it powers up, no frequency display, the
> meter lamps are very dim and all the LED lamps for controls on the front
> are lit.
>
>
>
> I’m hoping it’s not the dreaded controller board failure.
>
>
>
> Anyone seen this one before.  Tried a different power supply and it did
> the same thing.
>
>
>
> Strange evening...
>
>
>
> The Orion II still works quite well though....😊
>
>
>
> Thanks,
>
> Cecil Acuff
> Gulfport MS
> K5DL
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
<Prev in Thread] Current Thread [Next in Thread>