John -
You need a separate serial cable with nan interface on the rig end to
send CW. There are sample circuits on the N3FJP web site.
73 de K1ESE
John
On 10/10/2013 10:06 AM, JOHN wrote:
good morning gang
I have an omni 6 runing n3fjp softwave , i am using a w1gee interface from
the computer to the ci/v jack on the rear of the omni , control of the rig is
fine, however i can not send cw , i am almost 99% sure i did this in the past ,
any ideas would be appreciated
73 john ku3g
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|