What other connections are there between the microkeyer II and the O2? The
PTT IN is an input FROM the Orion TO the microkeyer. I doubt that this
could be the root cause of the problem.
Ted W4NZ
-----Original Message-----
From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of Rod Greene
Sent: Thursday, December 05, 2013 5:44 PM
To: microham@yahoogroups.com; orion565@yahoogroups.com;
tentec@contesting.com
Subject: [TenTec] Transmit not stopping when PTT is released
I just installed a new to me microKeyer II. Trying to follow the setup
instructions in the manual, I connected a mono cable (RCA plugs) between Amp
Key 1 on the O2 and PTT IN on the mK2. When the O2 is keyed (via footswitch
or VOX) the O2 stays in transmit when the foot switch is released. Only way
to get the O2 out of transmit is to turn its power switch off.
Is this controlled by a setting I may have missed? I've read through the
manual until I'm blue in the face ... As long as I don't connect this cable
between Amp Key 1 and PTT IN everything seems to work okay.
Also - running the rig into a dummy load to eliminate RFI in the shack
doesn't make any difference.
For now I'll just not connect this cable. Not sure I need it, but haven't
yet tried the mK2 with N1MM or any other software.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|