| To: | tentec@contesting.com |
|---|---|
| Subject: | [TenTec] Ten Tec Centaur 411 10m Mod Needed |
| From: | "Doug Ellmore Sr." <doug@ellmore.net> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Thu, 13 Feb 2014 08:10:30 -0500 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
I just acquired a Ten Tec Centaur 411 amp from an SK estate. As it turns out, it was never updated for 12/10m use. Ten Tec noted they did not have the board to enable 10m. Any suggestions on a possible source or circuit diagram would be appreciated. Doug Ellmore, Sr. NA1DX / P40DE _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [TenTec] TenTec Argonaut 509, jliving39 |
|---|---|
| Next by Date: | Re: [TenTec] TenTec Argonaut 509, Doug Reid |
| Previous by Thread: | [TenTec] TenTec Argonaut 509, jliving39 |
| Next by Thread: | Re: [TenTec] Ten Tec Centaur 411 10m Mod Needed, w8au |
| Indexes: | [Date] [Thread] [Top] [All Lists] |