Perry
If your coming to the Mansfield hamfest Sunday, bring that info with you. I can
easily lay out a pcb for the amp.
Mike wb8vge
Sent from my iPhone
> On Feb 13, 2014, at 1:39 PM, w8au@sssnet.com wrote:
>
> At 08:10 AM 2/13/2014, you wrote:
>> I just acquired a Ten Tec Centaur 411 amp from an SK estate. As it turns
>> out, it was never updated for 12/10m use. Ten Tec noted they did not have
>> the board to enable 10m. Any suggestions on a possible source or circuit
>> diagram would be appreciated.
>
> Doug:
>
> Had to do this to our club Centaur. TT no longer has the plug in board but
> will supply the pi-section filter schematic/parts values for it. You have to
> fabricate your own board, which goes in place of the 15 meter output filter.
>
> Have fun..
>
> Perry w8au
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|