The resistor probably gets pretty hot.
The diode string does not.
Also, with a diode string, you can select more than one speed, if desired.
At the end of the day, "poor cat"; loses its skin, one way or the other.
73 - Rick, DJ0IP
(Nr. Frankfurt am Main)
-----Original Message-----
From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of K8JHR
Sent: Friday, March 07, 2014 9:19 AM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] Noise from Fans
I made a fan built into my shelf system to help the amp vent hot air.
I used an Off-On-Off switch with a single resistor to accomplish that
feat. This gives me high and low speed with just a flick of the switch.
Why is a diode better than a resistor? OR is it just another way to skin
the same cat?
I will have to send you some photos off list, as it turned out nicely.
I did this even though I think I cut enough air holes in the shelf to
accommodate the hot air, but figured this would be better in any case -
cannot be too safe, ya know.
------------------- K8JHR --------------------
On 3/7/2014 2:51 AM, Rick - DJ0IP / NJ0IP wrote:
> That is very good.
> Try using diodes instead of a resistor.
> Use a string of 1N4004 or similar.
> Each diode drops a good half volt.
> You can even make it multi speed if you add a small switch.
>______________________________________________
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|