I just short the FSK input to ground for LOW and apply +5V for FSK high.
73Bob K4TAX
> Bob, How do you adjust FK low and High?
>
> To get to fsk you hit fsk and CW, then tune to transmit.
>
> OK, then adjust appropriate cap for fsk low.
>
> If you then adjust appropriate cap for FSK high is their some other
> procedure to add, or do you just move to high cap and adjust cap?
>
> Reason I ask, is because you will be at your previous setting for FSK
> low.
>
>
> Then it says RTTY receive LSB is 90003000. This is merely LSB receive
> setting, correct? Had no problem here.
>
> had no problem at USB at 9000000 or CW Transmit at 90007000.
>
> I had lsb USB and CWT all ok, figured all would be ok.
>
> Thanks for the guide on fsk hi/low.
>
>
> ----- Original Message -----
> From: "Robert Mcgraw" <rmcgraw@blomand.net>
> To: "Mark Kenward" <k8vf_mark@centurytel.net>; "Discussion of Ten-Tec
> Equipment" <tentec@contesting.com>
> Sent: Monday, April 07, 2014 9:01 AM
> Subject: Re: [TenTec] Paragon II LSB/USB audio differences.
>
>
>> The BFO oscillators likely need alignment. Follow the sequence in the
>> manual.
>>
>> 73 Bob, K4TAX
>>
>>> i have set Reference oscillator , and the BFO's on the rig.
>>>
>>> Rig is on frequency as discussed a week or so ago.
>>>
>>> My issue is this.
>>>
>>> USB sounds great on transmit.
>>>
>>> LSB, however, is thin. Narrow, like you are talking through a 1.8-2.1
>>> kHz
>>> filter.
>>>
>>> I tried another 2.4 filter in 9mHz slot, with no change.
>>>
>>> Can someone tell me what to adjust to move the USB and LSB transmits
>>> more
>>> to the center of their respective ranges.
>>>
>>> I am happy with the rig so far, but it is obvious that LSB needs an
>>> adjustment, and of course, it is not the BFO.
>>>
>>> I have a friend who wants the rig, and I would like to make it perfect
>>> for him.
>>>
>>>
>>> Thanks for any help.
>>>
>>> Mark
>>> K8VF
>>> _______________________________________________
>>> TenTec mailing list
>>> TenTec@contesting.com
>>> http://lists.contesting.com/mailman/listinfo/tentec
>>>
>>
>>
>> --
>> Disclosure:
>> I am a Tentec Ambassador and compensated according to the Tentec
>> Ambassador plan. I serve as a volunteer beta test person for the Omni
>> VII, Eagle and Argonaut VI products. Otherwise, I hold no business or
>> employment interest with Tentec.
>>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
--
Disclosure:
I am a Tentec Ambassador and compensated according to the Tentec
Ambassador plan. I serve as a volunteer beta test person for the Omni
VII, Eagle and Argonaut VI products. Otherwise, I hold no business or
employment interest with Tentec.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|