I must admit that the LED matrix used on the O2 is very elegant. I know of no
other radio that displays the VFO status quite like that. Most of the time, the
status is annuciated somewhere in the display. It is on the O2 as well, but
additionally via the LED matrix, which is what I tend to check when I need to
know.
Kim N5OP
________________________________
From: Barry N1EU <barry.n1eu@gmail.com>
To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Sent: Tuesday, April 8, 2014 2:46 PM
Subject: Re: [TenTec] USER INTERFACE: Wish List for ORION-III
What if both receivers are tied to vfoA (or vfoB)?
That's why the Orion switch/LED matrix is so elegant as implemented. And
it's the only radio that has ever featured such a beautiful scheme.
73, Barry N1EU
On Tue, Apr 8, 2014 at 7:15 PM, Marsh Stewart <marsh@ka5m.net> wrote:
> Re: User Interface
>
> What I would like to see added to the Orion III are 4 additional indicator
> LEDs - one green for receive and one red for transmit for both VFO A and
> VFO
> B. Of course both VFOs could be selected at the same time for receive, but
> only one VFO could be selected for transmit. These indicator lights should
> be on the front face above each VFO's tuning knob.
>
> This is one person's opinion, mine, and I understand that others may not
> agree. This added feature might not be particularly useful to contesters,
> but DXers working split would probably appreciate it.
>
> Marsh, KA5M
>
>
> -----Original Message-----
> From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of PA5MW,
> Mark
> Sent: Tuesday, April 08, 2014 12:15 PM
> To: tentec@contesting.com; jhenry@tentec.com
> Subject: [TenTec] USER INTERFACE: Wish List for ORION-III
>
> Dear,
>
> We have been discussing the ORION III within our contest team and
> clubstation (2x 565+1x 566) for some time now.
> We would like to express our vision, but divided it in separate main
> areas so others can chime in.
>
>
> ORION III User Interface:
>
> - Leave the current form factor as is.
>
> - Large knobs plse.
>
> - It was and still is innovative; TenTec was and still IS ahead of
> competition
>
> - Keep the current Large ANALOG S-meter
>
> - Keep the TX/RX antenna VFO matrix switching board (Sublime ! Ever
> tried a K3-disaster?)
>
> - Keep the large VFO knobs (plse never exchange it for that dull
> miniature as found on K3/FT5K/IC78)
>
> - Keep showing functions and current settings on display
>
>
> What upgrades for the UI?
>
> - Modular display setup per user. (screen totally changes in design and
> functions, tailored to user)
>
> - Start from a few generic interface designs like
> DX'er/Contester/RTTY/Ragchewer.
>
> - Make it fully customizeable, so users can enable/disable
> functions/buttons etc. from the screen.
>
> - More color settings, or again; customizable
>
> - Please DO NOT try to copycat 'fashion stuff' from competition
>
> - Focus on supplying the 'fun factor' in operating the rig
>
> - Add new interface comm like USB and other, to accommodate
> contesting/dx software
>
> - Think about a restricted/easy to use pre-defined (receiver)settings
> (for those hams who just want to do simple radio like an old TS850)
>
> - Do not add bandscope, unless it can do waterfall at the realtime speed
> like any decent SDR
>
> - Keep doing what TenTec does best; deliver a great transceiver with an
> innovative user interface, supplying the biggest fun factor in Hamradio.
>
>
> 73 Mark, PA5MW
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|