TenTec
[Top] [All Lists]

Re: [TenTec] RX366 9 MHz Out

To: "TenTec@contesting.com" <tentec@contesting.com>
Subject: Re: [TenTec] RX366 9 MHz Out
From: P C A <xtraham58@hotmail.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Tue, 13 May 2014 19:49:24 -0400
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
WOW, everyone is missing my point. I would not spend any more money on the Oll. 
Now, I have a classic Harley Davidson Motorcycle that I have spent in excess of 
3k on chrome to make it mine. I have Lionel Trains (standard gauge ) that were 
my Dad's.  As an x Corp pilot I have help restore several aircraft. You see, we 
all have our gigs. I just can not see spending money on the Oll. Better radio's 
will come along.
Andy

> 
> 
> That's a rather presumptuous thing to say, Andy. Not to make too fine a 
> point of it, but I make decisions in this regard that please me. 
> Therefore, what anyone else thinks, or might think, of it isn't 
> particularly relevant to what I decide.
> 
> But, since you asked, I'll address your question. I tend to keep radios 
> a long time when I like them. I like the O II and I know TT will support 
> it for quite a while, yet. I have a TS-930S, long since a fossilized 
> horse. Yet, long after it was out of production, I bought a PIEXX 
> microprocessor board for it. Then, in a fit of unparalleled 
> irrationality I bought an INRAD roofing filter for it!
> 
> But wait! It gets better. I have a Hammarlund HQ-170 receiver that I 
> have used since I was first licensed as WN5CLC in 1970. My dad (W5JHJ 
> SK) kept it in pristine condition from the day he bought it in 1959. I 
> have continued the tradition and have spent money on it for various 
> replacement parts. I also have a WRL Globe Champion 350, also my dad's 
> and that I used since I was licensed. I've actually modified it to make 
> it more robust, have improved the power supply, and added fuse 
> protection for the LV supply transformer.
> 
> But the peak of insanity lies in my purchase, restoration, use and 
> continued maintenance of a 1946 Cessna 140. That airplane was out of 
> production in 1949! The engine hasn't been made by Continental motors 
> for decades. What must I have been thinking?!
> 
> Economically, it's all quite silly. But it also makes me very happy.
> 
> So, why do spend the money, time (my only nonrenewable resource), and 
> effort on all these "dead horses?" Because, as far as I can tell, they 
> are still quite animate and keeping them around and caring for them 
> gives me great pleasure.
> 
> 73,
> 
> Kim N5OP
> 
> On 5/13/2014 4:12 PM, P C A wrote:
> > Kim, can not understand why you would spend the money on a dead horse. The 
> > Oll is obsolete, I know I own one.Andy, W3LI
> >
> >>
> >> Kim, FYI I posted to this list about my lack of success using the RX366
> >> 9MHz output to drive LP-PAN (w preamp).  I believe the VE7TK mod that adds
> >> a Clifton Labs buffer amp to generate the 9MHz output will probably yield
> >> much more satisfactory results.
> >>
> >> 73/GL,
> >> Barry N1EU
> >>
> >>
> >> On Tue, May 13, 2014 at 1:36 AM, Kim Elmore 
> >> <cw_de_n5op@sbcglobal.net>wrote:
> >>
> >>> I've just finished the installation of my new (and, apparently last) RX366
> >>> into my Orion II. Being the kind of ham that wants to have all the bells
> >>> and whistles available, even if I don't have the ability to use them right
> >>> now, I decided to go ahead and take advantage low-level the 9 MHz output
> >>> from the RX366. I obtained a length of coax with TMP connectors on both
> >>> ends and looked up the 9 MHz output mod by VE7TK. To my astonishment, I 
> >>> see
> >>> that one of the unused TMP receptacles on the back of the unit (the one
> >>> next to where cable 3 plugs in) goes to the RCA jack on the back labelled
> >>> "SPARE." I double checked and, sure enough, there's a DC path to the
> >>> "SPACE" RCA jack on the back. KEWL!
> >>>
> >>> So, apparently, all I need now is an LP PAN adapter unit with a preamp and
> >>> I'll be cookin' with a real-time spectrum display.
> >>>
> >>> Kim N5OP
> >>>
> >>>
> >>> _______________________________________________
> >>> TenTec mailing list
> >>> TenTec@contesting.com
> >>> http://lists.contesting.com/mailman/listinfo/tentec
> >>>
> >> _______________________________________________
> >> TenTec mailing list
> >> TenTec@contesting.com
> >> http://lists.contesting.com/mailman/listinfo/tentec
> >                                     
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> >
> 
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
                                          
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>