Palstar uses a 3 pin Foster plug on some of its products - virtually
impossible to mess that up unless you are trying to force it in. No
more dangerous than forcing an 8-pin foster plug on the front of the
rig. The contacts are recessed inside the plastic/bakelite holder, so
it would be difficult to make a mistake.
===================== K8JHR ==============================
On 6/4/2014 11:10 AM, Rick - DJ0IP / NJ0IP wrote:
I didn't say it was bad, I just said "interesting".
Never tried it. I wonder if it is possible to accidently slightly plug it
in backwards, just far enough to make a brief contact?
_____________________________________________________
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|