TenTec
[Top] [All Lists]

Re: [TenTec] More Junk....

To: "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
Subject: Re: [TenTec] More Junk....
From: "Jerry Haigwood" <jerry@w5jh.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 4 Jun 2014 20:42:26 -0500
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Barry,
     Congratulations on winning the QRPTTF.  You had an impressive score!

Jerry W5JH
"building something without experimenting is just solder practice"

-----Original Message-----
From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of Barry N1EU
Sent: Wednesday, June 04, 2014 11:35 AM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] More Junk....

I think it has dual DACs and two hardware DDC receivers.

Barry N1EU


On Wed, Jun 4, 2014 at 2:49 PM, Duane Calvin <ac5aa1@gmail.com> wrote:

> And, it appears to have only one slice (receiver) plus RIT/XIT.  Hmm, must
> be more to it than that with all the antenna connectors.
>
>         73, Duane
>
> Duane Calvin, AC5AA
> Austin, Texas
> www.ac5aa.com
>
>
>
>
> -----Original Message-----
> From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of Tom
> Pennebaker
> Sent: Wednesday, June 04, 2014 9:37 AM
> To: TenTec@contesting.com
> Subject: [TenTec] More Junk....
>
> If you will look closely at the rear picture, you can detect poor
> quality. I bought a Russian CW paddle years ago, it is pure JUNK!!! The
> rear photo shows the possibility of junk. Where are you going to get it
> serviced when it fails? A Rolls Royce isn't any good if you can't get it
> seviced.....
> CW IT'S STILL MAGIC.... Tom N4RS
>
> > On Jun 4, 2014, at 8:20, Barry N1EU<barry.n1eu@gmail.com>  wrote:
> >
> > I know we've recently discussed SDRs on the reflector so please excuse
> this
> > off-topic post.  There's a nice looking SDR in the works out of Russia
> with
> > its own front panel.  It actually has an embedded i5 processor.  It is
> > going to be introduced at Friedrichshafen.  There have been quite a few
> > youtube videos of it in prototype phase over the past year or so.
Here's
> a
> > photo:http://sunsdr.com/images/fbfiles/images/SunSDR2_MB1_1_.jpg
> >
> > I don't know anything else about it.
> >
> > 73, Barry N1EU
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>