TenTec
[Top] [All Lists]

Re: [TenTec] Scout has vy low Pwr out on some bands

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Scout has vy low Pwr out on some bands
From: Mike Bryce <prosolar@sssnet.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Tue, 15 Jul 2014 13:43:16 -0400
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Don't forget to check/clean the connectors inside the radio, too

Mike wb8vge
Sent from my iPhone

> On Jul 15, 2014, at 1:23 PM, "Rick - DJ0IP / NJ0IP" <Rick@DJ0IP.de> wrote:
> 
> Mike,
> 
> I was thinking along those lines too.
> They "look" ok but it's hard to say.
> I was thinking about bending a burnishing tool 90 degrees (in its length),
> and then just polishing the pins.
> It's hard to believe the capacitors or inductors would have died.
> Dirty contacts are much more logical, especially because 40m was
> intermittent, and the rig has been sitting un-used for about 10 years.
> 
> I'll keep you posted.
> 
> 73 - Rick, DJ0IP
> (Nr. Frankfurt am Main)
> 
> 
> -----Original Message-----
> 
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>