TenTec
[Top] [All Lists]

Re: [TenTec] OMNI-D Series C

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] OMNI-D Series C
From: "R. Eric Sluder via TenTec" <tentec@contesting.com>
Reply-to: "R. Eric Sluder" <resluder@yahoo.com>, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Thu, 21 Aug 2014 17:16:11 -0400
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Rick,

I agree with your assessment and I appreciate the brick wall variable filtering 
of dsp.  I'm not fond of the dsp NR in the IF based systems.  Like you, I've 
found an external dsp unit does wonders on general noise via the audio route.  
I use that a lot on noisy nights verses the built in NR. 

As others have noted... The OMNI VII is gentler on the ears when using the 
built in NR and I'll use it sometimes with pleasing results.

Gosh now I want an Omni D Series C!!! I need to look at the balance in my bank 
account and that'll cool my heals real quick! :-)

73

-Eric
W9WLW

> On Aug 21, 2014, at 4:41 PM, "Rick - DJ0IP / NJ0IP" <Rick@DJ0IP.de> wrote:
> 
> Ralph, there is a simple explanation of why you need DSP.
> 
> First the industry builds radios for us with much more sensitivity than we
> actually need, especially on the low bands, amplifying everything including
> the noise.
> Then they tell us we need DSP to reduce the noise and add it on for an extra
> few hundred bucks.
> The magazines do a whoopee-sh@t on how well the DSP reduces the noise and
> Joe Ham swallows it.
> 
> Seems the old radios didn't need the DSP.
> When the noise got bad we reduced the RF gain and just forfeited the S-meter
> in exchange for good reception.
> So what.
> Now Ten-Tec has solved that bit too, with an S-meter that always reads
> accurately, regardless of preamp, ATT or RF gain setting.
> 
> There are times where DSP in the audio line will reduce the white noise.
> An external Audio DSP in the speaker or headphones line solves that and can
> be used with all the transceivers in the shack; you don't have to buy it
> over and over again with each transceiver.
> 
> AND DSP IF filtering does save on expensive Xtal filters.  And it does have
> steep skirts.  So I have to admit that this added value to the radios.
> 
> 73 - Rick, DJ0IP
> (Nr. Frankfurt am Main)
> 
> 
> -----Original Message-----
> From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of Ralph
> Arnold
> Sent: Thursday, August 21, 2014 5:36 PM
> To: Discussion of Ten-Tec Equipment
> Subject: Re: [TenTec] OMNI-D Series C
> 
> Hi Alex  I also have one TenTen Omni D  Bought it last July while up in
> Mich.  What a great Receiver low noise floor.  I thought it had a weak front
> end but when I adjusted the ant resonate Gang Busters.  I was really
> impressed. for an old radio  I don't see what all the whoop pla is about DSP
> if you got a good desing like that.  Gota go just thought I would throw
> in my two cents worth.  73s  KD8BTQ   Ralph
> 
> 
> On Thu, Aug 21, 2014 at 7:47 AM, Alexander N. Gerli <ac1wye@gmail.com>
> wrote:
> 
>> Hi folks!  Well, something new and different in the shack. I've been 
>> licensed since my 'teens (1964). It may have taken a few years (!), 
>> but I just got my first Ten Tec xcvr! My OMNI-D is loaded and has the 255
> P/S.
>> Even though it dates from the 1980s, it is a really nice radio. The 
>> first thing I noticed was the RX noise floor - very quiet. The counter 
>> timebase was off about 100Hz for WWV, and that was an easy adjustment.  
>> Beats me why I waited so long to get one of these. It is one fine rig.
>> 
>> Anxious to get on one of the Sunday Nets.
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>