I seem to recall that the amp interface has the correct cables already made.
Might check with Paul in service on this.
Bob, K4TAX
Sent from my iPhone
> On Sep 19, 2014, at 12:57 PM, John <k4avx1@windstream.net> wrote:
>
> I've used the ACC-1 connector that came with the Eagle to connect
> an amplifier interface.
>
> Unfortunately, due to the soft plastic or my poor soldering skills,
> it almost melted when I connected to it. In looking for a replacement,
> all the 8 pin mini-din plugs that I assumed it to be had the big
> key in the middle of them.
>
> Anyone know the correct nomenclature or part number from a
> retailer, Mouser, Digikey, etc? No, I don't want another one
> that I might melt. This is my most disliked connector to start
> with - too many small parts to assemble to make it whole.
>
> Thanks for any help.
>
> John, K4AVX
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|