TenTec
[Top] [All Lists]
<prev [Date] next>
[Advanced]
 <prev [Thread] next>

Re: [TenTec] din connector, etc.

from [Carl Moreschi] [Permanent Link][Original]
To: k9yc@arrl.net, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] din connector, etc.
From: Carl Moreschi <n4py3@earthlink.net>
Reply-to: n4py3@earthlink.net, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 24 Sep 2014 19:40:46 -0400
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
No it does not shorten the dit. Everything is just delayed by 18 msec. The start of the dit is delayed by 18 msec but the end of the dit is also delayed by 18 msec, causing the total length of the dit to be unchanged. 

Carl Moreschi N4PY
58 Hogwood Rd
Louisburg, NC 27549
www.n4py.com

On 9/24/2014 7:26 PM, Jim Brown wrote:

On Wed,9/24/2014 4:08 PM, Carl Moreschi wrote:

At 40 wpm, a dit time is 30 msec. So why would an 18 msec delay remove
QSK even at 40 wpm.


Because it shortens the dit by more than half.

73, Jim
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
[More with this subject...]
<Prev in Thread] Current Thread [Next in Thread>
Previous by Date:  Re: [TenTec] New Location ?, Richards
Next by Date:  Re: [TenTec] din connector, etc., Bob McGraw - K4TAX
Previous by Thread:  Re: [TenTec] din connector, etc., Jim Brown
Next by Thread:  Re: [TenTec] din connector, etc., Bob McGraw - K4TAX
Indexes:  [Date] [Thread] [Top] [All Lists]