This is how I understood the question.
73 - Rick, DJ0IP
(Nr. Frankfurt am Main)
-----Original Message-----
From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of Gary - AB9M
Sent: Friday, October 03, 2014 1:44 PM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] Modern version of the Tec Tec Corsair - please Ten
Tec!
The tale question referred to a Volt of RF on the RX antenna terminal.....
73 & DX,
Gary - AB9M
-----Original Message-----
From: Barry N1EU
Sent: Friday, October 03, 2014 3:18 AM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] Modern version of the Tec Tec Corsair - please Ten
Tec!
On Fri, Oct 3, 2014 at 12:23 AM, Gary - AB9M <glhuber@msn.com> wrote:
> Rick, is there any truth to the old RF Technician's tale that it takes
> more than a Volt of RF to overload a PTO on a Corsair II?
There is no RF input on a PTO.
73, Barry N1EU
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|