On 10/23/2014 1:54 PM, Richards wrote:
I have modest DIY sills and test equipment but I am game to try any
> diagnostic test within my skill level. Any ideas?
You've already mentioned this in another post, but it bears repeating:
DANGER! HIGH VOLTAGE!! Do NOT use your VOM to attempt to measure the
high voltage. Unless you have a special high voltage probe, it will
vaporize.
You could call Garry Green at the Mother Ship and run the symptoms by
him. At one time I seem to recall him saying something about a QSK board
failure under certain fault conditions.
I'm not familiar with the K2 watt meter or how it "breaks the key line".
You may want to disable/totally disconnect that feature and go directly
into a dummy load.
73,
Carter K8VT
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|