TenTec
[Top] [All Lists]

Re: [TenTec] How to Choose an SDR RX for the Pan-Adapter?

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] How to Choose an SDR RX for the Pan-Adapter?
From: Barry N1EU <barry.n1eu@gmail.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 27 Dec 2014 00:37:15 +0000
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
LP Bridge doesn't support Ten-Tec.  It's not an option.  "LPB2 provides
support for K2, K3, Yaesu (950,2000,5000) and Kenwood."

Barry N1EU

On Fri, Dec 26, 2014 at 11:28 PM, Richards <jrichards@k8jhr.com> wrote:

> I found the N4PY control program to be  1) easier to set up, and 2)
> quicker to get reliable and stable - compared with LPB2.  Not that the
> latter does not get it right, but it just went smoother the first time out
> with the N4PY program.
>
> Just My take.
> -------------------------- K8JHR  --------------------------
>
> On 12/26/2014 12:51 PM, Carl Moreschi wrote:
>
>>
>> Also, my N4PY software fully supports LPPan and interfacing to NaP3
>> without using LPBridge.  LPBridge sometimes can create timing problems.
>>
> _____________________________________
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>