FWIW, here is a link to the Ten Tec Wiki entry for the Model 215
microphone, originally sold for use with the 540 (and others). You may wish
to compare the specs with the mike you are using to see if they are
reasonably close.
http://www.tentecwiki.org/doku.php?id=215
Reed / WW3A
On Sat, Apr 4, 2015 at 6:12 PM, Bill Acito <w1pa@hotmail.com> wrote:
> I have a Delta and Omni-A, so I am setting the ALC/Drive correctly. I'll
> try taking the finals out of the equation. I also note there are bias
> settings on both the finals and the OT-TR assembly that I will look at.
> Anything else that could be causing overdrive with correct ALC/Drive
> settings on the front?
> I keep getting these rigs where it looks like folks went in with a golden
> screwdriver and tried to get 500W out of 100W rigs...
>
> Bill W1PA
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|