Re: [TenTec] Using a Mac to install OMNI VII firmware

[Clayton Brantley via TenTec <tentec@contesting.com>]

You might check with the guys in Sevierville, but I don't think the updates 
will work with anythingBUT a Windows PC.  I use Linux as my main computer but I 
keep a PC around for what you aretaking about.
Clayton N4EV

      From: "Silevitch, Michael" <m.silevitch@neu.edu>
 To: "TenTec@contesting.com" <TenTec@contesting.com> 
 Sent: Sunday, May 10, 2015 8:14 AM
 Subject: [TenTec] Using a Mac to install OMNI VII firmware
   
I have just purchased an OMNI VII and will be updating the firmware. I would 
prefer to use my Mac computer rather than a PC for this. I have a serial to USB 
adapter which should work to connect the OMNI to the Mac (or PC for that 
matter.) Any guidance would be appreciated. 

I may also want to operate the OMNI remotely using a Mac rather than a PC. 
Again any advice would be appreciated. 

Regards
    Michael K1PEV

Sent from my iPad
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec


  
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec