Sorry to say, the mac’s won’t work. UNLESS you run “Parallels” a windows
emulator
Mike, WB8VGE
SunLight Energy Systems
The Heathkit Shop
http://www.theheathkitshop.com/ <http://www.theheathkitshop.com/>
J e e p
o|||||||o
A man with one clock knows what time it is. A man with two clocks is never
sure.
> On May 10, 2015, at 11:39 AM, Clayton Brantley via TenTec
> <tentec@contesting.com> wrote:
>
> You might check with the guys in Sevierville, but I don't think the updates
> will work with anythingBUT a Windows PC. I use Linux as my main computer but
> I keep a PC around for what you aretaking about.
> Clayton N4EV
>
> From: "Silevitch, Michael" <m.silevitch@neu.edu>
> To: "TenTec@contesting.com" <TenTec@contesting.com>
> Sent: Sunday, May 10, 2015 8:14 AM
> Subject: [TenTec] Using a Mac to install OMNI VII firmware
>
> I have just purchased an OMNI VII and will be updating the firmware. I would
> prefer to use my Mac computer rather than a PC for this. I have a serial to
> USB adapter which should work to connect the OMNI to the Mac (or PC for that
> matter.) Any guidance would be appreciated.
>
> I may also want to operate the OMNI remotely using a Mac rather than a PC.
> Again any advice would be appreciated.
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|