Thanks for the info Gary.
Jock N1JI
On Fri, Jul 3, 2015 at 9:31 PM, Gary - AB9M <glhuber@msn.com> wrote:
> I have a Ten Tec Model 263 VFO, which had the "jump" problem. The LED
> BARGRAPH Calibration procedure in the 263 manual fixed mine. You need a
> Corsair-II with working digital frequency readout to do the calibration. I
> did not have an RF Volt meter (or oscilloscope) which is needed for the
> "BALANCE" adjustment.
>
>
> 73 & DX,
>
> Gary - AB9M
>
> -----Original Message----- From: Jock Irvine
> Sent: Friday, July 03, 2015 5:33 PM
> To: Discussion of Ten-Tec Equipment
> Subject: [TenTec] Model 263 External VFO for sale
>
>
> Ten Tec Model 263 VFO
>
> This is the matching external VFO for the Corsair. There is a small
> problem with the Receive-B button that I called Ten Tec about just before
> they moved to their new location. They said that an alignment would
> probably fix it but, since I don't have an RF volt meter, I never attempted
> it. I will email the buyer a PDF copy of the manual and the alignment
> procedure is in there.
>
> This is the problem; The PTO is stable, but when you depress the Receive-B
> switch the frequency jumps all over the place. It works fine if you press
> Receive A&B and pan the control all the way to B, which is how I was using
> it for split operation up until the day I sold my Corsair last May.
>
> Some scratches on the left side, otherwise in very good condition.
>
> Price is $100 (including shipping) in the continental USA.
>
> Please contact me for photos or other information.
>
> 73,
>
> Jock N1JI
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|