It's good to know there are some Dragonball CPUs still available. Thanks for
sharing.
If you wouldn't mind sharing the info, specifically which model Dragonball
CPU does the Orion use?
73,
Marsh, KA5M
-----Original Message-----
From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of Tim
Wininger
Sent: Thursday, March 24, 2016 3:51 PM
To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Ten-Tec Repair Service -5 Stars
Your correct Marsh. All functioning except the com port.....
Just found some new old stock Dragonball CPU's on Ebay the same model as
used in the Orion.
Will have to find out if TT able to replace them at this time for future
reference as I have four Orions currently. Obsolescence is inevitable in
todays technologies unfortunately.
GL with your Orion II.
GD,
Tim , AB4B
On Thu, Mar 24, 2016 at 3:05 PM, Marsh Stewart <marsh@ka5m.net> wrote:
> Tim,
>
> Thanks for sharing your recent experience with Ten-Tec repair service.
>
> I am a bit confused though. You wrote "I just had an Orion and Orion
> II repaired both of which are on their way back to me." Further on in
> your post you wrote " Orion had com port (RS-232 ) problem ( lightning
> damage) which couldn't be resolved as it got to the Dragon Ball CPU (
> no longer available)". Of course it is beyond Ten-Tec's control if a
> part is no longer available. So, as I read it, the Orion was repaired
> except for the RS-232 port? Or do I misunderstand?
>
> To me Jim Brown K9YC was making a comment on what I had written in my
> first post " From my first e-mail until FedEx delivered the
> transceiver back to me was only about 4 weeks. You may or may not
> consider that "fast", but I think that was pretty quick." Jim was
> sharing info he had about turn-around times for repairs from another
> transceiver manufacturer. In my view his comment was relevant to the
> thread. Just my opinion.
>
> 73,
> Marsh, KA5M
>
>
> -----Original Message-----
> From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of Tim
> Wininger
> Sent: Thursday, March 24, 2016 1:00 PM
> To: Kimberly Elmore <cw_de_n5op@sbcglobal.net>; Discussion of Ten-Tec
> Equipment <tentec@contesting.com>
> Subject: Re: [TenTec] Ten-Tec Repair Service -5 Stars
>
> I just had an Orion and Orion II repaired both of which are on their
> way back to me. 1.5 weeks round trip. Orion had com port (RS-232 )
> problem ( lightning damage) which couldn't be resolved as it got to
> the Dragon Ball CPU ( no longer available) and a couple of other
> associated issue which I wasn't aware of repaired. The Orion II had a
> com port problem and was repaired without any other issues discovered.
> Also had batteries replaced in both radios.
>
> The cost was minimal with 1.5 hrs bench time for both. The phoncons
> were very informative and cordial. I couldn't ask for any better
> communications in this evolution. I gave the service department my
> heartfelt thanks and encouraged them to keep at.
>
> So the beat goes on...........
>
> GD to all ,
>
> Tim, AB4B
>
> obtw...I really don't care what Elecraft service is , does or has
> done as it is irrelevant to this reflector IMHO
>
>
> On Thu, Mar 24, 2016 at 12:40 PM, Kimberly Elmore <
> cw_de_n5op@sbcglobal.net>
> wrote:
>
> > I'm curious about what failed. ANy details?
> > Kim N5OP
> >
> > From: Marsh Stewart <marsh@ka5m.net>
> > To: Ten-Tec <tentec@contesting.com>
> > Sent: Thursday, March 24, 2016 11:57 AM
> > Subject: [TenTec] Ten-Tec Repair Service -5 Stars
> >
> > I just wanted to share my very recent experience with Ten-Tec repair
> > service..
> >
> > After years of dependable service my Orion II broke. I sent an
> > e-mail to service@tentec.com describing the problem and requesting a
> > RA number. I received a prompt reply with an RA number and ship-to
address.
> >
> > My Orion II was shipped back to Ten-Tec, repaired, aligned, tested,
> > and returned to me. The charge was less than expected. From my first
> > e-mail until FedEx delivered the transceiver back to me was only
> > about 4
> weeks.
> > You
> > may or may not consider that "fast", but I think that was pretty quick.
> >
> > I have no knowledge of the overall status of Ten-Tec, and your
> > experience may be different, but in my experience Ten-Tec Repair
> > Service is alive and well.
> >
> > Marsh, KA5M
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|