You might check the diodes on the VSWR circuit board.
73 ES DX,
Gary - AB9M
On 11/13/2016 3:16 PM, Steve Berg wrote:
> I fired up my Corsair II to check into the Ten Tec nets today. It
> receives fine, but when I tried to transmit on SSB, the ALC light lit
> up solidly, and it took backing way down on the drive level to make it
> stop. I haven't used it much this summer, but I had it on for about 5
> hours before the net times. Luckily, I was able to check in on the 20
> meter net with my Argo VI barefoot.
>
> This is a new problem with the radio, so where might I start looking?
>
>
> 73,
>
> Steve WA9JML
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|