Re: [TenTec] TX Audio Problems With Corsair II

[Steve Berg <wa9jml@frontier.com>]

It works fine on cw, which is what I normally use.

Steve WA9JML


On 11/13/2016 5:57 PM, GARY HUBER wrote:
> You might check the diodes on the VSWR circuit board.
>
> 73 ES DX,
> Gary - AB9M
>
> On 11/13/2016 3:16 PM, Steve Berg wrote:
> > I fired up my Corsair II to check into the Ten Tec nets today. It
> > receives fine, but when I tried to transmit on SSB, the ALC light lit
> > up solidly, and it took backing way down on the drive level to make it
> > stop.  I haven't used it much this summer, but I had it on for about 5
> > hours before the net times.  Luckily, I was able to check in on the 20
> > meter net with my Argo VI barefoot.
> >
> > This is a new problem with the radio, so where might I start looking?
> >
> >
> > 73,
> >
> > Steve WA9JML
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec