Then its probably not the diode problem. Have you tried operating the
ALC, Process, and Drive controls to clean any dirt or corrosion from the
pots? I periodically operate all the pots and switches on my Corsair II
and ext VFO, just keep them clean. These old radios seem to get more
problems from lack of use than from operation. TELCO jacks and switches
had the same issue when not operated.
73 ES DX,
Gary - AB9M
On 11/13/2016 6:02 PM, Steve Berg wrote:
> It works fine on cw, which is what I normally use.
>
> Steve WA9JML
>
>
> On 11/13/2016 5:57 PM, GARY HUBER wrote:
>> You might check the diodes on the VSWR circuit board.
>>
>> 73 ES DX,
>> Gary - AB9M
>>
>> On 11/13/2016 3:16 PM, Steve Berg wrote:
>>> I fired up my Corsair II to check into the Ten Tec nets today. It
>>> receives fine, but when I tried to transmit on SSB, the ALC light lit
>>> up solidly, and it took backing way down on the drive level to make it
>>> stop. I haven't used it much this summer, but I had it on for about 5
>>> hours before the net times. Luckily, I was able to check in on the 20
>>> meter net with my Argo VI barefoot.
>>>
>>> This is a new problem with the radio, so where might I start looking?
>>>
>>>
>>> 73,
>>>
>>> Steve WA9JML
>>>
>>> _______________________________________________
>>> TenTec mailing list
>>> TenTec@contesting.com
>>> http://lists.contesting.com/mailman/listinfo/tentec
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|