You might want to try and find where the hum is entering the system. I
have done this before by using a 1uf cap to ground and touching the cap to
the input of each stage. Remember to discharge the cap between each stage.
Jeff
On Jun 3, 2017 8:32 PM, "Josh Gibbs" <gibbsjj@gmail.com> wrote:
> My shielding attempts made no difference. I also unbolted the transformer
> so I could move it around slightly (as much as the leads would allow). That
> had no effect.
>
> I think my next step will be to remove the transformer + power board from
> the chassis and run it on the bench. That should stop the noise if its
> magnetic. Might replace the bridge rectifier while I have the power board
> out.... its a $2 part (VJ048 - NTE53000 equivalent).
>
> -Josh WA7FPV
>
> On Sat, Jun 3, 2017 at 2:53 PM, Gary F <dukeshifi@comcast.net> wrote:
>
> > If those are cracked, I guess I wold replace them.
> >
> > They likely will not fix the hum but should not be left if cracked.
> >
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|