Turn tx power down to see if there is a power level that does not cause the
problem, just to confirm it really is an RF problem. Try connecting radio
directly to dummy load and see if problem goes away, If you can run full
power into a dummy load and not have the problem, then you can probably
make the problem go away with changes to your RF cabling in the shack.
Perhaps quarter wave counterpoise wires connected to your operating table
ground buss.
DE N6KB
On Tue, Jul 11, 2017 at 3:44 PM, Michael Tortorella <w2iy@verizon.net>
wrote:
> Hello to the list, I am using DXLab and N1MM+ with my Eagle. Both programs
> work nicely until I press the key, then the com port goes dumb and the PC
> no
> longer follows the radio. Sure sounds like RF is getting into the PC, so I
> have disconnected all the cables (power and LAN) and put ferrites on the
> USB
> cable to the Eagle but this has not solved the problem. The PC is a
> Toshiba
> Satellite C55 laptop, I do not see any place where I can ground the case to
> the radio which I would like to do. Any other suggestions I can try?
>
> Thanks in advance for any help. 73, Mike W2IY
>
>
>
> ---
> This email has been checked for viruses by AVG.
> http://www.avg.com
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|