Hi Bob,
This is my vacation setup so I do not have access to much else, not even a
dummy load. I did order a double-shielded USB cable which should get here
next week. I disconnected everything from the laptop except the USB cable
and the problem still happens. I would like to figure out how to ground the
laptop to the radio but there do not seem to be any reachable ground contact
points, some inspiration will be needed here. I am hoping to get this
squared away before the IOTA contest which I hope to run from here on
NA-055.
Thanks and 73
Mike W2IY
-----Original Message-----
From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of Katz Ajamas
Sent: Thursday, July 13, 2017 6:53 AM
To: ah7i@gatech.edu
Cc: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] Eagle CAT com port goes dumb on transmit
are you using the more than one cable to the laptop?
try keying rig with only the USB control cable and a manual key.
On Thu, Jul 13, 2017 at 10:50 AM, Katz Ajamas <ajamas.rn@gmail.com> wrote:
> try with dummy load. try a different USB cable. does it happen on all
> bands?
> 73, -bob ah7i
>
> --
> -do not look into LASER with remaining eye!
>
--
-do not look into LASER with remaining eye!
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
---
This email has been checked for viruses by AVG.
http://www.avg.com
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|