Hi all, I am hearing an awful lot of steady carrier signals up here in the
frozen north of Downeast Maine. Most are not very strong and they go away
when I disconnect the antenna so they are external to the radio. Today I am
chasing TR8CA on 20 CW, he is way down in the noise, and 100 Hz away from
one of these carriers. Sure would be nice to have something like a notch
filter to help in situations like these but I could not see anywhere in the
manual or front panel where I could notch the offending carrier. Is there
any list wisdom on this?
On another note, I did contact service at TT last week with my question
about power out in autotune; after only a few days delay I got an answer
that the power out in autotune is 20 watts even though the power output
shown on the display is 100. This seems not quite right from a human
factors point of view, maybe there can be a firmware fix? Also, when
exchanging VFOs, the A,B labels do not change even when the B vfo is in
large type at the top of the display. I find this confusing. OK, I guess
this turned into a longer letter about a couple of other things besides
notch filtering, so please excuse my prolixity and thank for the BW. Any
suggestions appreciated.
Thanks and 73, Mike W2IY
---
This email has been checked for viruses by AVG.
http://www.avg.com
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|