On 07/30/2017 02:04 PM, Barry N1EU wrote:
Stan, if the 288 filter is plugged into your 9MHz i.f. board, remove it and
install it properly on the PBT board. That is a 6.3MHz i.f. filter.
73, Barry N1EU
Hi Barry,
Yep, it looks like someone put that filter in the wrong slot. I put it
on the PBT board and the 1.8 Khz bandwidth setting works now. Thanks!
I sent a message to the list with a pic of the 2 filters attached. But,
it was too large and got put on hold.
Thanks again for your help.
73
Stan
KM4HQE
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|