Barry is Da Man!
<span style="font-size: 16px;">
</span><div>I agree with leaving well enough alone
on the 20 and 40 hz problem.
My Omni 6 Plus was always dead on until I had to do some work on the Osc. board
a year or so ago.
It's now 20 hz off on all bands and modes but it's operationally perfect
otherwise and I'm not gonna tempt OM Murphy.
Sent from AOL Mobile Mail
-----Original Message-----
From: Stan Gammons <s_gammons@charter.net>
To: tentec <tentec@contesting.com>
Sent: Sun, Jul 30, 2017 03:41 PM
Subject: Re: [TenTec] Omni VI questions
On 07/30/2017 02:04 PM, Barry N1EU wrote:
> Stan, if the 288 filter is plugged into your 9MHz i.f. board, remove it and
> install it properly on the PBT board. That is a 6.3MHz i.f. filter.
>
> 73, Barry N1EU
>
>
Hi Barry,
Yep, it looks like someone put that filter in the wrong slot. I put it
on the PBT board and the 1.8 Khz bandwidth setting works now. Thanks!
I sent a message to the list with a pic of the 2 filters attached. But,
it was too large and got put on hold.
Thanks again for your help.
73
Stan
KM4HQE
_______________________________________________
TenTec mailing list
<a href="mailto:TenTec@contesting.com";>TenTec@contesting.com</a>
<a href="http://lists.contesting.com/mailman/listinfo/tentec";
target="_blank">http://lists.contesting.com/mailman/listinfo/tentec</a>
</div>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|