| To: | "'tentec@contesting.com'" <tentec@contesting.com> |
|---|---|
| Subject: | [TenTec] Omni VI Plus front panel |
| From: | "Gary Hendricks" <k4mt1950@charter.net> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Mon, 23 Apr 2018 12:30:35 -0600 |
| List-post: | <mailto:tentec@contesting.com> |
I can not find a schematic that shows the MS MT LP AND NR buttons and where they go to on I assume the logic board. Anyone know where that schematic might be found Gary K4MT _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Omni VI Plus front panel issue, MadScientist1948 |
|---|---|
| Next by Date: | Re: [TenTec] Omni VI Plus front panel, Barry N1EU |
| Previous by Thread: | [TenTec] Omni VI Plus front panel issue, Gary Hendricks |
| Next by Thread: | Re: [TenTec] Omni VI Plus front panel, Barry N1EU |
| Indexes: | [Date] [Thread] [Top] [All Lists] |