Barry:
I found the problem. Conn 96 now feeds the leds I was talking about.
The plug on the logic board someone had plugged in a pin off
Now all is well
Thanks
Gary K4MT
-----------------------------------------From: "Barry N1EU"
To: "Discussion of Ten-Tec Equipment"
Cc:
Sent: Monday April 23 2018 2:09:21PM
Subject: Re: [TenTec] Omni VI Plus front panel
The lines come into the logic board on the bottom right side of the
schematic (p 4-20) - connectors 91 and 92
Barry N1EU
On Mon, Apr 23, 2018 at 8:02 PM, Barry N1EU wrote:
> The buttons/switches are shown in figure 4-34 on page 4-33
>
> Barry N1EU
>
> On Mon, Apr 23, 2018 at 6:30 PM, Gary Hendricks
> wrote:
>
>> I can not find a schematic that shows the MS MT LP AND NR buttons
and
>> where they go to on I assume the logic board. Anyone know where
that
>> schematic might be found
>> Gary K4MT
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
/> >>
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
/>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|