Yes I saw that page but if diodes in diag are supposed to be the leds
there is none for LP or NR. Can not find those LEDS referenced
anywhere
Gary K4MT
-----------------------------------------From: "Barry N1EU"
To: "Discussion of Ten-Tec Equipment"
Cc:
Sent: Monday April 23 2018 2:02:30PM
Subject: Re: [TenTec] Omni VI Plus front panel
The buttons/switches are shown in figure 4-34 on page 4-33
Barry N1EU
On Mon, Apr 23, 2018 at 6:30 PM, Gary Hendricks
wrote:
> I can not find a schematic that shows the MS MT LP AND NR buttons
and
> where they go to on I assume the logic board. Anyone know where
that
> schematic might be found
> Gary K4MT
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
/> >
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
/>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|