No, because he is seeing full current draw in transmit.
The power is being produced by the final amp. just not getting to the antenna
jack, signifying a bad d/R relay.
Gary
> On Oct 10, 2018, at 3:14 PM, Carl Moreschi <n4py3@earthlink.net> wrote:
>
> Finals blown?
>
> Carl Moreschi N4PY
> 58 Hogwood Rd
> Louisburg, NC 27549
> www.n4py.com
>
> On 10/10/2018 2:41 PM, Joe Word wrote:
>> My Pegasus has no transmit output.
>>> Receive works fine.
>>> No output on any band on CW or SSB.
>>> Red TX light comes on.
>>> It does draw power supply current changing with power setting.
>>> SSB TX sounds good in monitor.
>>> Has LDG tuner, no change if bypassed.
>>> Running Ten-Tec software.
>>> I have unplugged, cleaned and reconnect connectors,
>>> I see no physical component damage.
>>
>> Any thoughts?
>>
>> Joe N9VX
>>
>>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|