TenTec
[Top] [All Lists]

Re: [TenTec] Omni 6 won't boot up

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Omni 6 won't boot up
From: Madscientist1948 <dukeshifi@comcast.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Thu, 29 Nov 2018 11:11:37 -0600
List-post: <mailto:tentec@contesting.com>
Yes, I measured it right at the clock chip.

Gary

Sent from my iPad

> On Nov 29, 2018, at 9:49 AM, Bill Cotter <n4lg@qx.net> wrote:
> 
> Gary,
> 
> Is the RTC battery still providing energy?
> 
> 73 Bill N4LG
> 
> At 09:49 PM 11/28/2018, you wrote:
>> H Greetings: I have an Omni 6 that starts boot up, goes through the process 
>> of turning the S meter lamps on, then stops with all pushbuttons LED’s lit. 
>> I checked the 20 MHz oscillator (good) and I checked all of the CPU address 
>> lines and data lines, all of which are active. The only thing  I have found 
>> so far is that the real time clock, DS1285, which has a small crystal for 
>> its timebase, is not running. What I wanted to learn is whether or not the 
>> CPU will boot up without this cook’s being in operation. It seems to me 
>> that, since this is a real time clock, it should be running all of the time, 
>> even when the radio is off, and the DS1285 should keep time powered by the 
>> backup battery. Gary _______________________________________________ TenTec 
>> mailing list TenTec@contesting.com 
>> http://lists.contesting.com/mailman/listinfo/tentec
> 
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
<Prev in Thread] Current Thread [Next in Thread>