I have used a 12vdc relay and use the contacts to switch the 120v
Sent from Mail for Windows 10
From: Rick@dj0ip.de
Sent: Tuesday, February 25, 2020 5:41 PM
To: 'Discussion of Ten-Tec Equipment'
Subject: Re: [TenTec] Eagle & Heath SB-200 Amp
Actually there are various kits for installing inside of the SB-200 that
present a 12v keying circuit.
That's why I said he needs to tell us exactly how the amp has been modified,
with circuit drawing.
I don't recall all of the names and sources; one was called a soft key, and
used solid state keying that could handle the 120 volts, yet presents 12v to
the transceiver.
That's why I also said STOP, DON'T DO ANYTHING . . . until we find out.
Otherwise there will be an expensive repair to the Eagle.
73,
Rick, DJ0IP
(Nr. Frankfurt, Germany)
May the Sunspots be with us!
-----Original Message-----
From: TenTec <tentec-bounces+rick=dj0ip.de@contesting.com> On Behalf Of Bob
McGraw K4TAX
Sent: 25 February 2020 17:40
To: tentec@contesting.com
Subject: Re: [TenTec] Eagle & Heath SB-200 Amp
WOAH! STOP! If the amp has not been modified for the KEY circuit, it has
120 volts on the center pin of the RCA connector. If this is connected to the
Eagle it will immediately destroy the Eagle PTT Amp control circuit.
The amp relay must be changed to a 12 volt relay and other circuit
modifications done, OR you must use an Amp Interface between the radio and the
amp.
Who ever gave you the information DOES NOT know what they are talking about.
This is normal for most hams unless they have actually interfaced the SB-200 to
the Eagle. MFJ did make an interface suitable for the application.
As Will Rogers said: "it's not what people know that concerns me, it is what
they know that is not correct that gives me concerns".
If you need additional information, I'll be glad to assist.
73
Bob, K4TAX
On 2/25/2020 8:13 AM, Richard Wagner via TenTec wrote:
> I’ve never dealt with an Amplifier before. A friend gave me a Heath SB-200.
> It appears I have to make a connection between the AMP KEY terminal of the
> ACC-1 accessory connector and the AMP KEY Socket of the amp. A plug for the
> socket and short jumper wire were included with my Eagle. This appears to be
> all that is needed. I’ll connect from the Eagle to the Amp then through my
> Antenna Tuner to the Antenna. Does this seem OK?
>
> Rich Wagner
> K4MZE
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|