Re: [TenTec] Eagle & Heath SB-200 Amp

[Radio AI2Q <ai2q@roadrunner.com>]

Sometimes a short delay has to be added between the time your rig is 
keyed and the amp is keyed. To be clearer, the amplifier must be keyed 
first, to ensure its T/R relay is connected to your antenna before RF is 
applied. Delays are typically in tens of milliseconds.
Vy 73, /AI2Q/, Alex


On 2/25/2020 9:13 AM, Richard Wagner via TenTec wrote:
> I’ve never dealt with an Amplifier before. A friend gave me a Heath SB-200. It appears 
> I have to make a connection between the AMP KEY terminal of the ACC-1 accessory connector and 
> the AMP KEY Socket of the amp. A plug for the socket and short jumper wire were included with 
> my Eagle. This appears to be all that is needed. I’ll connect from the Eagle to the 
> Amp then through my Antenna Tuner to the Antenna. Does this seem OK?
>
> Rich Wagner
> K4MZE
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec