I would look for a parts radio! Bad cpu. There out there but hard to have
anyone give them up. That’s my opinion. AC9PA Byron
Sent from my iPad
On Jun 13, 2020, at 5:48 AM, Barry Simpson <vk2bj@optusnet.com.au> wrote:
Following on from my two previous posts, I had been experiencing the start
up issues for a few days and was going to get on with the A9 recap very
soon.
However, when the rig was booting up this morning, I caught a glimpse of a
small flash from the screen area. When it all settled down, I saw that the
screen has suffered two noticeable damage marks in between and level with
the top of the first two digits of the sub display.
They look like burn/short circuit marks and I wonder of that was what
caused the failure of one of the 22 ohm resistors in A9 - or vice versa.
Is there any source for replacement screens or do I just have to live with
it and hope that it doesn't get worse ?
Barry VK2BJ
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|