TenTec
[Top] [All Lists]

Re: [TenTec] Filters for Omni V.9

To: tentec@contesting.com
Subject: Re: [TenTec] Filters for Omni V.9
From: "Petr Ourednik" <indians@xsmail.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 24 Jun 2020 11:09:23 +0200
List-post: <mailto:tentec@contesting.com>
...so sorry > now again with correct filters numbers :)

Hi folks,

as I decided to dust off from my Omni V.9 after some time I put it on the table 
and run during this weekend in AA contest. 
Receiver is stellar and looks ok. Just I will have to replace CR2032 button 
cell on logic board as it does not remember last settings after turning OFF...

The question...
Which kind of filter > 217(0.5k) or 219(0.25k) I should try to buy and install 
into my OV.9 on 9MHz IF stage NAR pos please? I have 6.3MHz IF stage fully 
loaded and would like to get max selectivity on CW.

...or even better the Inrad 753? 

Thanks for hint which one and if possible where to buy (has someone on the 
shelf or in junk box unused please?)

Best regards,
-- 
73 - Petr, OK1RP
--
B: http://goo.gl/Fd2JhJ
YT: https://urlzs.com/UHNH9
MeWe: https://bit.ly/2HGPoDx
MeWe: https://bit.ly/2FmwvDt
--
What could be easier..?  ¯‍∖‍_‍(‍ツ‍)‍_‍/‍¯

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
<Prev in Thread] Current Thread [Next in Thread>